Concrete Contractor in Salem Lakes, WI

Concrete work in Salem Lakes

Salem Lakes has a village formed from Salem and Silver Lake, with lake homes and rural acreage. What that means for concrete here is Wisconsin village specs, lake-community lots and the same freeze-thaw cycle as the Illinois side. We work out of Waukegan, which puts Salem Lakes well inside our normal radius, and because we handle tear-out and the new pour with one crew there is no gap between trades.

What concrete is up against in Salem Lakes

Lake County sits on clay that holds water instead of draining it, and the freeze-thaw cycle here runs from November into March. Add the salt that goes down after every storm and you have the three things that kill concrete. Slabs that survive are air-entrained, poured on a compacted stone base, pitched so water leaves, jointed on a proper grid, and kept off salt through their first winter.

Around Salem Lakes the recurring theme is age. A lot of the flatwork here went down decades ago, before compacted stone base was standard on residential work, and it is at the end of a life it was never engineered for.

• Control joints cut late or shallow. Concrete is going to crack. Joints decide where. Cut at the wrong depth or a day late and the slab picks its own line across the middle.
• Settled and heaved sections. Where the slab is sound but has dropped, lifting or a single section replacement costs a fraction of a full tear-out.
• Road salt damage. De-icing salt accelerates surface scaling badly. New concrete should not see salt through its first winter and should be sealed before the second.
• Freeze-thaw scaling. Water gets into the surface, freezes and lifts the top layer off in flakes. It comes from too much water in the mix, finishing while bleed water is still on the slab, or skipping the air entrainment exterior concrete needs here.

Services we offer in Salem Lakes

Every one of these has a page specific to Salem Lakes.

How a Salem Lakes job runs

1. Walk the drive and quoteWe look at how the old slab failed, where water goes, and what the driveway carries, then confirm thickness, reinforcement and finish.
2. Tear out and haulThe old slab is broken out and hauled off, along with the failed base underneath it.
3. Excavate and compactDown past disturbed material, graded stone in, compacted in lifts.
4. Form and reinforceForms set to the drainage slope. Rebar or mesh on chairs, not on the ground.
5. Pour, finish, jointPlaced, screeded, floated and finished. Control joints cut the same day.
6. Cure and cleanCured to the weather, edges cleaned, debris gone. We tell you when to walk it and when to drive it.

What we check before quoting in Salem Lakes

• Access. Whether a truck can back up to the work or everything moves by buggy and wheelbarrow. On the tighter lots around Salem Lakes that is half the labor.
• What is under the slab. If the base was never compacted it has to come out, not get covered over.
• Where the water goes. Grade, downspouts and yard drainage.
• Public way. Aprons and walk sections usually need a permit and have to meet village spec.
• What it carries. A work truck, boat trailer or RV means thicker concrete and more steel.
• Disposal. Concrete is priced out by weight, and an honest quote includes the haul.

Before we arrive

• Clear vehicles, trailers and anything stored on the slab the night before
• Leave an outside spigot reachable
• Mark any private irrigation, invisible fence or low-voltage lighting lines in the work area
• Plan for no vehicle access across the work for about a week after the pour
• Keep pets and kids off fresh concrete until we say it is ready
• If a village permit is involved, allow time for it before the pour date

Nearby towns

We are also regularly in Paddock Lake, Silver Lake, Bristol, Antioch and Twin Lakes. Salem Lakes is just over the state line from Waukegan and inside our normal radius. No separate travel charge. The full list is on the areas page.

Salem Lakes FAQ